OBD, OBD on Bench, and Boot
Version 7.42.0.0 of Flex out now introducing full support to Magneti Marelli 8GMC control modules installed on American market Fiat 500 cars.
Program via the diagnostic port: read, make your modifications (like power increase) and write your file directly on the module.
If the vehicle is not available, you can work in OBD on Bench and program the ECM via connector.
In order to carry out cloning or recovery operations, you can operate in Bootloader, too, opening the module and connecting to the PCB.
Some of the supported vehicles:
- Fiat 500 (312) 1.4L MultiAir 16v 102PS
- Fiar 500 (312) 1.4L Fire 16v 102PS
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Boot
- FLS0.4M – SW Flex Boot Nexus MPC5xxx Master
- FLS0.4S – SW Flex Boot Nexus MPC5xxx Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(OBD)
- FCA Marelli 8GMC MPC5565 Read/Write/Checksum Calculation Internal Flash
Reading Time : ~ 2 minutes Writing Time : ~ 2 minutes
(Boot)
- FCA Marelli 8GMC MPC5565 Read/Write/Checksum Calculation Internal Flash, Read/Write External EEPROM, Full Backup, Clone
Reading Time : ~ 2 minutes Writing Time : ~ 1 minute and 30 seconds
