Fomoco UTCU3 TCMs Now Covered
New version 7.47.0.0 of Flex out now, introducing a new protocol dedicated to Fomoco UTCU3 TCMs installed on Ford vehicles with 6, 8, and 10-speed automatic transmissions.
With the new Flex release, you can perform OBD programming of a wide range of vehicles that are equipped with this control module, by connecting directly to the diagnostic port.
Operating in OBD means getting quick access to the map area, making it possible to carry out necessary modifications to optimize transmission performance.
Some of the supported vehicles:
- Ford Bronco (VI) (2020MY) 2.7L Ecoboost V6 335PS
- Ford Kuga (III) (2020MY) 1.5L EcoBoost 150PS
- Ford Ranger T6 (2019MY) 2.3L Ecoboost 270PS
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(OBD)
- Ford Fomoco UTCU3 TC277 Read/Write/Checksum Calculation Maps
Reading Time : ~ 10 minutes Writing Time : ~ 15 minutes
