Version 6.49.0.0 of Flex out now
New protocol out now on Flex to program 2nd gen Getrag DC4 automatic transmissions.
With this latest update (ver 6.49.0.0), it is now possible to connect TCUs both in Bench and Boot modes.
You can now access the whole content of Internal Flash and Internal EEPROM memories and unlock the potential of Renault, Dacia, and Smart TCUs equipped with Gen2 DC4 Getrag units.
Some of the supported vehicles:
- Dacia Duster II 1.3L TCe 150PS
- Renault Megane IV 1.5L Blue dCi 115PS
- Renault Twingo III 0.9L TCe 90PS
- Smart Forfour W453 0.9L Turbo 90PS
- Smart Forfour W453 1.0L 70PS
This new protocol is available for the following software packages:
Bench
- FLS0.2M – SW Flex TCU OBD/Bench/Boot (car, bike, van) Master
- FLS0.2S – SW Flex TCU OBD/Bench/Boot (car, bike, van) Slave
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(Bench)
- All Getrag DC4 Gen2 TC1782F Reading/Writing/Checksum Calculation Internal Flash, Reading Internal EEPROM, Reading Full Backup
Reading Time: ~ 1 minute Writing Time: ~ 40 seconds
(Boot)
- All Getrag DC4 Gen2 TC1782F Reading/Writing/Checksum Calculation Internal Flash, Reading Internal EEPROM, Reading Full Backup
Reading Time: ~ 40 seconds Writing Time: ~ 30 seconds
Bug Fix:
- Fix read size for FCA Continental GPEC2
- Fix update write for newest VAG BOSCH MD1CP014 TCxxx
Software Improvements:
- Added the recognition of the full readout for Gm Delco T87
