Version 6.50.0.0 of Flex out now
A new protocol for Land Rover vehicles is now available on Flex: with this latest software update, you will be able to program MD1CP007 engine units in Bench mode.
Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start working: you will optimize performances of vehicles such as Defender and Range Rover or remove trouble codes from Bosch MD1CP007.
Please note: Flex V1 will soon be disabled.
Download the setup of Flex V2 latest version here and install the new interface in a few simple steps*
*If your subscription is temporarily inactive, you can still use Flex V2. However, the Datalogger feature as well as protocols released after the expiration of your subscription will not be available.
Some of the supported vehicles:
- Land Rover Defender L663 3.0L MHEV 203PS Hybrid
- Land Rover Defender L663 3.0L MHEV 304PS Hybrid
- Land Rover Range Rover L460 3.0L MHEV 253PS Hybrid
- Land Rover Range Rover L460 3.0L MHEV 304PS Hybrid
This new protocol is available for the following software packages:
Bench
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5M – SW Flex Full Slave
Newly added protocols:
(Bench)
- JLR Bosch MD1CP007 TC298 Read/Write/Checksum Calculation Maps, Read/Write Internal EEPROM
Reading Time: ~ 1 minutes and 30 seconds Writing Time: ~ 1 minutes
Bug Fix
- Added new CRC type for PSA Continental SID80x
- Added new CRC type for VAG Bosch MD1CS004
- Added new CRC type for FCA Marelli MM10JA
- Added new CRC type for Mercedes Continental ACM2.1 D3
Software Improvements
- Improved identification process on FCA Continental GPEC2
