Version 6.59.0.0 of Flex out now
New solution for Bosch MSE6.0 and US6.0 released on Flex.
With this new update, connection modes for MSE6.0 and US6.0 engine units increase: as of today, in addition to the OBD protocol (released in version 6.56.0.0) you will be able to program in Bench, too.
Get access to the full content of control units installed on over 40 models of motorcycles, including Benelli and CF Moto, and elaborate the unit according to your needs.
Thanks to this protocol, you can now restore a damaged ECU by reading the content of the original one and writing it on the working unit.
Please note: Both units need a voltage higher than 14V, thus the new DC/DC converter (FLX4.92) is necessary for programming.
DC/DC Converter – FLX4.92
The new DC/DC Converter receives voltage by Flex and makes it possible to adjust output values in a range between 0.0V and 36V, thus allowing an accurate monitoring of the voltage in order to meet different operational needs.
Compatible units:
- Marelli 6F3 – Bench
- Marelli 6JF – Bench
- Marelli 6JO – Bench
- Marelli 6O2 – Bench
- Marelli 6O3 – Bench
- Bosch MSE6.0 – Bench
- Bosch US6.0 – Bench
Buy the new DC/DC Converter on www.magicmotorsport.shop, or ask for it in the online chat or via the Commercial Request ticketing system offered by Magicmotorsport.
Discover how the new DC/DC Converter works, watch the tutorial here
Some of the supported vehicles:
- Benelli 502C 500cc 48PS
- Benelli TRK 502 500cc 48PS
- CF ZForce 550cc 31PS
- CF Moto CForce 963cc 68PS
- CF Moto NK 149cc 13PS
This new protocol is available for the following software packages:
Bench
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.13M – SW Flex Bikes OBD/Bench/Boot Master
- FLS0.13S – SW Flex Bikes OBD/Bench/Boot Slave
Newly added protocols:
(BENCH)
- All Bosch MSE6.0 SPC563 Read/Write/Checksum Calculation Internal Flash
Reading Time: ~ 20 seconds Writing Time: ~ 1 minute
- All Bosch US6.0 SPC563 Read/Write/Checksum Calculation Internal Flash
Reading Time: ~ 20 seconds Writing Time: ~ 1 minute
Bug Fixes:
- Fixed Continental SDI9, SDI10.x and SDI21.x connection error in boot mode
- Fixed CRC type for All Bosch MED17.8.10
- Added new CRC type for Renault Continental EMS3120
- Added new CRC type for Ford Delphi MPC555
