OBD Connection for Ford USA
Version 7.34.0.0 of Flex out now, introducing OBD programming for a wide range of Bosch control modules installed on Ford USA vehicles: MG1CS060, MG1CS055, MG1CS040, and MD1CP062.
With this new update, you can now access ECM calibration data in just a few minutes, directly via the diagnostic socket, without the need to carry out complex procedures nor invasive interventions.
Thanks to this new support, modifying the engine map area becomes easier and more efficient: optimize performance, improve vehicle response, and reduce consumption, quickly and accurately.
Some of the supported vehicles:
- Ford F-150 XIV 3.5L 450PS
- Ford F-250 Super Duty V 6.8L 400PS
- Ford F-650 Super Duty VIII 6.7L V8 330PS
- Ford Bronco VI 2.3L EcoBoost 280PS
- Volkswagen Amarok II 2.3L TSI
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(OBD)
- Ford Bosch MD1CP062 TC389 Read/Write/Checksum Calculation Maps
- Ford Bosch MG1CS040 TC399 Read/Write/Checksum Calculation Maps
- Ford Bosch MG1CS055 (beta) TC389 Read/Write/Checksum Calculation Maps
- Ford Bosch MG1CS060 TC387 Read/Write/Checksum Calculation Maps
Reading Time : ~ 6 minutes Writing Time : ~ 4 minutes
