Flex Version 7.33.0.0 Update Ready
With the release of Flex software version 7.33.0.0, OBD programming is now available for Bosch VD1CP110 control modules, used in the management of AdBlue systems.
In just a few minutes, you will have direct access to the ECM calibration data through the diagnostic port, or, if the vehicle is not available, you can also proceed via the ECM connector.
Thanks to this exclusive feature of Flex, you can use automatic solutions such as error code removal or AdBlue system deactivation—all in total safety and in just a few minutes.
Some of the supported vehicles:
- Ford Ranger IV 2.0L EcoBlue 170PS
- Ford Tourneo Customer II 2.0L EcoBlue 140PS
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
(OBD)
- Ford Bosch VD1CP110 TC375 Read/Write/Checksum Calculation Maps
Reading Time : ~ 4 minutes Writing Time : ~ 3 minutes
