New OBD protocol for Continental Simos 19.7

New OBD protocol for Continental Simos 19.7

Version 6.51.0.0 of Flex out now A new solution is now available on Flex to program Continental Simos 19.7 engine control units in OBD. The quick connection to the diagnostic port of the vehicle allows you to work without the need to remove nor to open the ECU. With this new protocol, you will be able to
Bench Solution for MD1CP007

Bench Solution for MD1CP007

Version 6.50.0.0 of Flex out now A new protocol for Land Rover vehicles is now available on Flex: with this latest software update, you will be able to program MD1CP007 engine units in Bench mode. Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start

New road driving simulation for 4WD

Version 1.1.0 of Dynomag Hub out now New software release out now for 4WD road driving simulation tests, allowing Dynomag Hub to simulate the force of a vehicle in motion on a smooth, level surface, free from tire rolling resistance, driveline losses and aerodynamic drag. Briefly, this kind of tests simulate the same force exerted by the road

Bench and Boot solution for Gen2 Getrag DC4

Version 6.49.0.0 of Flex out now New protocol out now on Flex to program 2nd gen Getrag DC4 automatic transmissions. With this latest update (ver 6.49.0.0), it is now possible to connect TCUs both in Bench and Boot modes. You can now access the whole content of Internal Flash and Internal EEPROM memories and unlock the potential of Renault, Dacia, and Smart TCUs equipped with Gen2 DC4 Getrag units. Some of

OBD unlock for Porsche Bosch MG1CP007

Version 6.48.0.0 of Flex out now New protocol for Bosch MG1CP007 OBD unlock. Thanks to the direct connection to the diagnostic port, you will no longer need to bother removing the ECU from the vehicle: just connect the OBD cable of Flex and download the virtual read from our database to unlock the unit. You

New OBD solution for Continental Simos 19.3

Version 6.47.0.0 of Flex out now Download the new update of Flex, version 6.47.0.0, and recalibrate in OBD the map area of VAG vehicles equipped with Simos19.3. Thanks to the fast OBD connection, you won’t need to remove and open the ECU to access data in the map area. With this new solution, you will