Iveco Bosch MD1CS069 Now Ready
New Flex update, version 7.49.0.0, now available, implementing OBD programming for the most modern Iveco vehicles equipped with Bosch MD1CS069, even those produced after 2021.
Thanks to this new protocol, you can now work directly from the diagnostic port of the vehicle (bypassing the SGW module), or establishing direct connection through the connector.
As of today, working on the map area doesn’t require unlocking the control module nor shipping it to us: remove DTCs, boost engine performance, or cut consumption, all in a few minutes.
Some of the supported vehicles:
- Iveco Daily (IV) 2.3L FPT 16v 134HP
- Iveco Daily (IV) 3.0L FTP 16v 177HP
This new protocol is available for the following software packages:
OBD
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
Newly added protocols:
- Iveco Bosch MD1CS069 TC299 Read/Write/Checksum Calculation Maps
Reading Time : ~ 5 minutes Writing Time : ~ 2 minutes
