We are releasing ver 12.06.00 of MAGPro2 X17: this update, aside several software improvements, focuses on two important brands, for which we added exclusive new protocols:
1. Volvo, for which we added support both for tractors (with Kubota engine) and, most importantly, all 2.0 engines from 2014 to 2017 using Denso ECUs with processor SH72546R! This includes both diesel and petrol versions.
2. Ford, we added the new generation petrol engines – 1.0, 1.1 and 1.2 used on Fiesta and Ka+!
We are not done yet and working untirelessly to release some new interesting functions and protocols for next update!
New Protocols Added:
- Ford Bosch MED17.0.7 TC1782: Bootloader IROM, Read/Write/Checksum/Recovery, Bootloader EEPROM Read/Write/Checksum/Recovery
- Ford Bosch ME17.0.3 TC1724: Bootloader IROM Read/Write/Checksum/Recovery, Bootloader EEPROM Read/Write/Checksum/Recovery
- Ford Continental EMS2303 TC1724: Bootloader IROM Read/Write/Checksum/Recovery, Bootloader EEPROM Read/Write/Recovery
- Volvo Denso SH72546R MB279700: OBD UDS Read/Write/Checksum, Bench Read/Unlock (unlock on bench is needed before working in OBD!)
- Volvo (Kubota) Denso SH7058/SH7059 Bench Read/Write/Recovery
Software Improvements:
- Audi Continental Simos 6.2/6.3 OBD TP2.0: seed/key algo added
- Chevrolet Delco E98 OBD: added new checksum algo
- Chevrolet Delphi DCM3.7 Nexus OBD: protocol will now recognize this ECU type instead of reading an empty file. This ECU type remains unsupported.
- Citroen Bosch MED17.4.4: added new method to read pass
- GMC Delco E98 OBD: added new checksum algo
- Holden Delco E98 OBD: added new checksum algo
- Hyundai Continental SIM2K-251: added new checksum algo
- Kia Continental SIM2K-251: added new checksum algo
- Opel Delco E98 OBD: added new checksum algo
- Opel Delphi DCM3.7 Nexus OBD: protocol will now recognize this ECU type instead of reading an empty file. This ECU type remains unsupported.
- Peugeot Bosch MED17.4.4: added new method to read pass
- Vauxhall Delco E98 OBD: added new checksum algo
- Vauxhall Delphi DCM3.7 Nexus OBD: protocol will now recognize this ECU type instead of reading an empty file. This ECU type remains unsupported.
- VAG Bosch MEDC17 OBD UDS: if ECU requires unlock, software will now advise to do downgrade or upgrade specifying which software is available to patch.
- VAG Continental Simos OBD UDS: if ECU requires unlock, software will now advise to do downgrade or upgrade specifying which software is available to patch.
Bugfixes:
- VAG Bosch MEDC17: software will no longer give message “Cannot connect to server” in case file is not found.
- VAG Delphi DCM3.7: error checking dependencies solved during writing. Now writing will work OK in all cases.
You can click here to review the full list of supported vehicles by MAGPro2 X17.
