OBD and Bench for the 6-gear transmission module
New release with version 7.26.0.0 of Flex, focusing on OBD and Bench support for Denso SH72531 TCMs installed on Mazda vehicles.
Download the new software update to optimize gear shifting timing and improve the performance of your automatic transmissions.
With this new OBD protocol, you can seamlessly access the map area by connecting the OBD cable to the diagnostic socket of the vehicle, whereas with the Bench protocol you can now access the full content of Flash and EEPROM memories.
Some of the supported vehicles:
- Mazda 3 2.0L Skyactiv-G 120PS
- Mazda CX-5 2.0L Skyactiv-G 4×4 160PS
- Mazda 3 2.5L Skyactiv-G 4×4 195PS
This new protocol is available for the following software packages:
OBD/Bench
- FLS0.2M – SW Flex TCU OBD/Bench/Boot (car, bike, van) Master
- FLS0.2S – SW Flex TCU OBD/Bench/Boot (car, bike, van) Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.6M – SW Flex OBD/Bench/Boot Renesas SH7xxxx Master
- FLS0.6S – SW Flex OBD/Bench/Boot Renesas SH7xxxx Slave
Newly added protocols:
(OBD)
- Mazda Denso Skyactiv-Drive (TCU) SH72531 Read/Write/Checksum Calculation Maps
Reading Time : ~ 10 minutes Writing Time : ~ 2 minutes
(Bench)
- Mazda Denso Skyactiv-Drive (TCU) SH72531 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
Reading Time : ~ 1 minute Writing Time : ~ 30 seconds
Bug fixes:
- Added new CRC type for Subaru Denso SH7055
- Added new CRC type for Ducati Continental M4C
- Added new CRC type for VAG Continental SIMOS9.1
- Added new CRC type for Opel Bosch ME7.6.4
- Added new CRC type for Ford Delphi DCU20x
- Fixed External Flash detection on Volvo Bosch EDC17CP22
