Flex Version 7.29.0.0 Now Available
A new OBD Full protocol has been released for programming the Denso 112300-5920 engine control unit installed on the Suzuki Grand Vitara.
Thanks to this update, you can optimize the vehicle’s performance in just a few simple steps, without the need to remove or open the ECU.
The protocol allows reading and writing of both the Flash and EEPROM memory, enabling you to safely apply all necessary modifications directly through the diagnostic port.
Some of the supported vehicles:
- Suzuki Grand Vitara II 2.0L DOHC 140PS
This new protocol is available for the following software packages:
OBD Full
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.6M – SW Flex OBD/Bench/Boot Renesas SH7xxxx Master
- FLS0.6S – SW Flex OBD/Bench/Boot Renesas SH7xxxx Slave
- Newly added protocols:
- (OBD Full)
- Suzuki Denso 112300-5920 SH7058 Read/Write/Checksum Calculation Internal Flash, Read/Write External EEPROM, Full Backup
Reading Time : ~ 45 seconds
Writing Time : ~ 1 minute
