Version 6.51.0.0 of Flex out now
A new solution is now available on Flex to program Continental Simos 19.7 engine control units in OBD.
The quick connection to the diagnostic port of the vehicle allows you to work without the need to remove nor to open the ECU.
With this new protocol, you will be able to work on the map area of Audi engine units: download the virtual read of the SW version installed in the unit and access engine management parameters, you will thus improve efficiency and performance.
Moreover, this solution allows you to write ECU software updates: just select the version you wish to implement among the available ones in our database.
Please note: if the virtual read file is not available, choose another compatible version to update the software of your ECU
We remind you that Flex V1 will soon be disabled.
Download the Flex V2 setup here and install the new interface in a few simple steps*
*If your subscription is currently inactive, you can still use Flex V2. However, the Datalogger feature and protocols released after the expiration date of your subscription will not be available.
Some of the supported vehicles:
- Audi A4 2.0L MHEV TFSI 204PS
- Audi A5 2.0L MHEV TFSI 265PS
- Audi A6 2.0L MHEV TFSI 204PS
- Audi A7 2.0L MHEV TFSI 265PS
- Audi Q3 2.0L MHEV TFSI 230PS
- Audi Q5 2.0L MHEV TFSI 204PS
This new protocol is available for the following software packages:
OBD
- FLS0.1S – SW Flex ECU (car, van, bike) OBD + Bench;
- FLS0.1M – SW Flex ECU (car, van, bike) OBD + Bench;
- FLS0.5S – Flex Full SW Package;
- FLS0.5M – Flex Full SW Package.
Newly added protocol:
(OBD)
- VAG Continental Simos19.7 Virtual Read/Write/Checksum Calculation Maps, Write Update
Writing Time: ~ 2 minutes
Bug Fix
- Fixed CRC calculation for some versions of Marelli TCU
- Fixed CRC calculation for some Toyota Denso Gen3
- Added new CRC type for FCA Marelli MM10JA
- Added new CRC type for Mercedes Continental ACM2.1
- Added new CRC type for VAG Continental Simos 7.1
- Added new CRC type for Mazda Melco E6T
