Version 7.1.0.0 of Flex Out Now with the New Solution for Suzuki Mild-Hybrid
Download the newest version of the Flex software and enjoy the new solution for Suzuki Mild-Hybrid: work on Suzuki hybrid/petrol vehicles like Swift and Ignis.
As of today, you can program Bosch MG1CA002 control modules in Bench: get access to the full content of Flash and EEPROM memories directly via the ECM connector and boost vehicle performance or remove diagnostic trouble codes.
Some of the supported vehicles:
- Suzuki Swith 1.2L MHEV R4 (90PS)
- Suzuki Ignis II 1.2L MHEV Dualjet (84PS)
This new protocol is available for the following software packages:
Bench
- FLS0.1M – SW Flex ECU (car, van, bike) OBD/Bench Master
- FLS0.1S – SW Flex ECU (car, van, bike) OBD/Bench Slave
- FLS0.5M – SW Flex Full Master
- FLS0.5S – SW Flex Full Slave
- FLS0.10M – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Master
- FLS0.10S – SW Flex Bench/Boot Infineon TC17xx / TC2xx / TC3xx Slave
Newly added protocols:
(BENCH)
- Suzuki Bosch MG1CA002 SPC5898 Read/Write/Checksum Calculation Internal Flash, Read/Write Internal EEPROM, Full Backup
Reading Time : ~ 3 minutes Writing Time : ~ 5 minutes
Bug fixes
- Fixed writing error in some version of Kia / Hyundai CPEGD3.20.1 and CPEGP3.20.2
- Fixed writing error in Renualt Continental EMS3150 and EMS3155
Software improvements
- Added Bench support for Mazda Melco E6T6577x
- Added Bench support for PSA Bosch MED17.4.2 TC1767
- Added Boot support for FCA Marelli IAW5SF3
Discover the New solution for Suzuki Mild-Hybrid. Click here to discover the full list of supported vehicles.
