New protocols for CPC2

Version 6.52.0.0 of Flex out now Download the new software update of Flex and work on Mercedes vehicles equipped with CPC2 with TC1793 and TC1797 processors. Connect in Bootloader Powertrain control units and get access to the full content of Internal Flash and Internal EEPROM memories: you will be able to optimize torque and speed
New OBD protocol for Continental Simos 19.7

New OBD protocol for Continental Simos 19.7

Version 6.51.0.0 of Flex out now A new solution is now available on Flex to program Continental Simos 19.7 engine control units in OBD. The quick connection to the diagnostic port of the vehicle allows you to work without the need to remove nor to open the ECU. With this new protocol, you will be able to
Bench Solution for MD1CP007

Bench Solution for MD1CP007

Version 6.50.0.0 of Flex out now A new protocol for Land Rover vehicles is now available on Flex: with this latest software update, you will be able to program MD1CP007 engine units in Bench mode. Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start

New road driving simulation for 4WD

Version 1.1.0 of Dynomag Hub out now New software release out now for 4WD road driving simulation tests, allowing Dynomag Hub to simulate the force of a vehicle in motion on a smooth, level surface, free from tire rolling resistance, driveline losses and aerodynamic drag. Briefly, this kind of tests simulate the same force exerted by the road

Flex Book, the official user guide

For automotive professionals and enthusiasts Flex Book is here: the official guide describing all the features of the ECU and TCU programmer signed Magicmotorsport. Designed for automotive professionals and enthusiasts, it offers a comprehensive vision of Flex and its functioning. From protocols to connection modes, from user interface to key features, from case studies to concrete projects. This

Bench and Boot solution for Gen2 Getrag DC4

Version 6.49.0.0 of Flex out now New protocol out now on Flex to program 2nd gen Getrag DC4 automatic transmissions. With this latest update (ver 6.49.0.0), it is now possible to connect TCUs both in Bench and Boot modes. You can now access the whole content of Internal Flash and Internal EEPROM memories and unlock the potential of Renault, Dacia, and Smart TCUs equipped with Gen2 DC4 Getrag units. Some of