Flex version 8.13.0.0 is ready
Flex support for the VAG Group expands even further. With version 8.13.0.0, it is now possible to program the Bosch MG1CS111 ECU, equipped with a TriCore TC298 processor.
Thanks to Boot Glitch unlocking, it is possible to work on the ECU completely independently, including in Bench mode, without the need to ship it to our laboratories.
A solution that simplifies the workflow and ensures full control over the entire operation.
The new support is available to all customers with a Flex Full Master (FLS0.5M) or Flex Full Slave (FLS0.5S) license.
- VAG Bosch MG1CS111 TC298
- Working Mode: Boot Glitch – Bench
- Memories: Read/Write/Checksum Internal Flash, Read/Write Internal EEPROM, Full Backup, Boot Unlock
- Licenses: FLS0.5M/S
- Connect/Glitch Time: ~ 5 minutes
- Reading Time: ~ 2 minutes and 30 seconds
- Writing Time: ~ 2 minutes
Here are some of the supported vehicles:
- Audi A3 (III) 8V (2012MY) 2.0L TSI [CZPB] 187HP
- Cupra Formentor (I) (2020MY) 2.0L TSI [DKZA] 188HP
- Skoda Octavia (IV) NX (2020MY) 2.0L TSI 16v [DRFA] 187HP
- Volkswagen (VW) Arteon (I) 3H (2017MY) 2.0L TSI [CZPB] 187HP
- Volkswagen (VW) T-Roc (I) A1 (2017MY) 2.0L TSI [CZPB] 187HP
