Version 6.49.0.0 of Flex out now New protocol out now on Flex to program 2nd gen Getrag DC4 automatic transmissions. With this latest update (ver 6.49.0.0), it is now possible to connect TCUs both in Bench and Boot modes. You can now access the whole content of Internal Flash and Internal EEPROM memories and unlock the potential of Renault, Dacia, and Smart TCUs equipped with Gen2 DC4 Getrag units. Some of

Version 6.48.0.0 of Flex out now New protocol for Bosch MG1CP007 OBD unlock. Thanks to the direct connection to the diagnostic port, you will no longer need to bother removing the ECU from the vehicle: just connect the OBD cable of Flex and download the virtual read from our database to unlock the unit. You

Version 6.47.0.0 of Flex out now Download the new update of Flex, version 6.47.0.0, and recalibrate in OBD the map area of VAG vehicles equipped with Simos19.3. Thanks to the fast OBD connection, you won’t need to remove and open the ECU to access data in the map area. With this new solution, you will

Flex version 6.46.0.0 out now Program with Flex the last generation ZF 9-speed transmission unit. New exclusive solution released, completely free of charge, allowing you not only to read and write the map area but also to access the EEPROM memory. You can now optimize shift times or remove DTCs from the 9HP50 TCU installed

OBD Solutions for Nissan and Infiniti Program in OBD mode the engine control units BED310. A new update has been released to optimize the engine parameters of Nissan and Infiniti branded vehicles: access the maps area directly from the vehicle’s diagnostic port without having to remove the ECU. NOTE: For Keyless vehicles, it is necessary

Version 6.43.0.0 of Flex out now New protocol of Flex released to program Bosch MG1CS036 ECUs in Bench. From now on, you will be able to access Internal Flash and Internal EEPROM memories in Bench mode, to optimize engine maps or remove DTCs from Ford vehicles. This new solution allows you to work directly from