Flex version 6.46.0.0 out now Program with Flex the last generation ZF 9-speed transmission unit. New exclusive solution released, completely free of charge, allowing you not only to read and write the map area but also to access the EEPROM memory. You can now optimize shift times or remove DTCs from the 9HP50 TCU installed

OBD Solutions for Nissan and Infiniti Program in OBD mode the engine control units BED310. A new update has been released to optimize the engine parameters of Nissan and Infiniti branded vehicles: access the maps area directly from the vehicle’s diagnostic port without having to remove the ECU. NOTE: For Keyless vehicles, it is necessary

Version 6.43.0.0 of Flex out now New protocol of Flex released to program Bosch MG1CS036 ECUs in Bench. From now on, you will be able to access Internal Flash and Internal EEPROM memories in Bench mode, to optimize engine maps or remove DTCs from Ford vehicles. This new solution allows you to work directly from

Version 6.37.0.0 of Flex out now A new protocol adds up to Flex‘s vehicle list: from today on, you can work on Hitachi BED 434 ECUs in OBD mode. Elaborate engine parameters of vehicles from Renault or Nissan by accessing the map zone directly from the diagnostic port of the vehicle. With this new solution,

Version 6.36.0.0 of Flex out now New Flex update released for OBD Full programming of Continental EMS3150 and EMS3155 ECUs. With this new protocol, you will no longer need to remove the ECU from the vehicle to access the Full Backup: thanks to the fast connection to the diagnostic port, it is now possible to