VAG Bosch MG1CS111 TC298 without RFT

Flex version 8.13.0.0 is ready Flex support for the VAG Group expands even further. With version 8.13.0.0, it is now possible to program the Bosch MG1CS111 ECU, equipped with a TriCore TC298 processor. Thanks to Boot Glitch unlocking, it is possible to work on the ECU completely independently, including in Bench mode, without the need

RFT – Entrust Your MDG1 ECU to Us

The Ready For Tuning (RFT) service is fully operational and is continuously updated with the latest ECUs supported by Flex. If you own a Flex Full Master (FLS0.5M) or Flex Full Slave (FLS0.5S) license with an active subscription, you can already unlock supported ECUs directly in your own workshop using the latest solutions developed by Magicmotorsport. However, you can still choose
OBD and OBD on Bench for CPEGD3.20.1 and CPEGP3.20.2

OBD and OBD on Bench for CPEGD3.20.1 and CPEGP3.20.2

Flex Version 7.0.0.0 is ready Try the new OBD and OBD on Bench solutions for CPEGD3.20.1 and CPEGP3.20.2 available on Flex. With version 7.0.0.0 of Flex, we now support Kia and Hyundai vehicles with 1.0L, 1.2L, 1.5L, and 1.6L gasoline and hybrid-gasoline engines. Thanks to the new protocol, you can access the map area of the ECU Kefico CPEGD3.20.1 and

OBD Solution for Nissan

Version 7.3.0.0 of Flex out now Download the newest version of the Flex software and try out the protocols for Hitachi BED 430 and Hitachi BED 431 engine control units supported in OBD mode. Get access to the map zone of the unit from the diagnostic port of Nissan vehicles, such as Juke and Qashqai with 1.6L DIG-T

OBD unlock for Porsche Bosch MG1CP007

Version 6.48.0.0 of Flex out now New protocol for Bosch MG1CP007 OBD unlock. Thanks to the direct connection to the diagnostic port, you will no longer need to bother removing the ECU from the vehicle: just connect the OBD cable of Flex and download the virtual read from our database to unlock the unit. You

New OBD solution for Continental Simos 19.3

Version 6.47.0.0 of Flex out now Download the new update of Flex, version 6.47.0.0, and recalibrate in OBD the map area of VAG vehicles equipped with Simos19.3. Thanks to the fast OBD connection, you won’t need to remove and open the ECU to access data in the map area. With this new solution, you will