Version 6.52.0.0 of Flex out now Download the new software update of Flex and work on Mercedes vehicles equipped with CPC2 with TC1793 and TC1797 processors. Connect in Bootloader Powertrain control units and get access to the full content of Internal Flash and Internal EEPROM memories: you will be able to optimize torque and speed

Version 6.51.0.0 of Flex out now A new solution is now available on Flex to program Continental Simos 19.7 engine control units in OBD. The quick connection to the diagnostic port of the vehicle allows you to work without the need to remove nor to open the ECU. With this new protocol, you will be able to

Version 6.50.0.0 of Flex out now A new protocol for Land Rover vehicles is now available on Flex: with this latest software update, you will be able to program MD1CP007 engine units in Bench mode. Connect your Flex to the ECU connector to access the whole content of Internal Flash and Internal EEPROM memories, then start

Version 6.49.0.0 of Flex out now New protocol out now on Flex to program 2nd gen Getrag DC4 automatic transmissions. With this latest update (ver 6.49.0.0), it is now possible to connect TCUs both in Bench and Boot modes. You can now access the whole content of Internal Flash and Internal EEPROM memories and unlock the potential of Renault, Dacia, and Smart TCUs equipped with Gen2 DC4 Getrag units. Some of

Version 6.48.0.0 of Flex out now New protocol for Bosch MG1CP007 OBD unlock. Thanks to the direct connection to the diagnostic port, you will no longer need to bother removing the ECU from the vehicle: just connect the OBD cable of Flex and download the virtual read from our database to unlock the unit. You

Version 6.47.0.0 of Flex out now Download the new update of Flex, version 6.47.0.0, and recalibrate in OBD the map area of VAG vehicles equipped with Simos19.3. Thanks to the fast OBD connection, you won’t need to remove and open the ECU to access data in the map area. With this new solution, you will